ANTEC Performance 1 FT Gaming Case Black E-ATX Full Tower ARGB

The exterior design of the air intake is enhanced to provide good heat dissipation performance of the system. The front-access magnetic filter design is also convenient for users to install and clean. Full tower size, can install E-ATX motherboard up to 285mm wide.The front supports 420mm water cooling, the top supports 3 x 140mm fans, and the power supply compartment supports 3 x 120mm fans.Comes standard with 3 x TQ14x25mm PWM ARGB fans in the front and 1 x TQ 120x25mm PWM ARGB fan in the rear to speed up heat dissipation.An ARGB hub board is included, which can be integrated to synchronize the lighting effects of the motherboard (the hub board itself cannot control the lighting effects and needs to be linked through the motherboard. The hub board has four ARGB and a PWM interface, the first three fans will be connected to the PWM interface using a 1-to-3-point wiring) + a PWM fan 1-to-3-point cable is attached to facilitate the whole setup.The detachable fan water-cooling tray on the top plate not only facilitates the installation of heat dissipation components on the top but also eliminates the problem of interference when installing components on the front.The temperature display allows users to monitor the temperature of the CPU and GPU at any time through the screen.Fully-open PCIe graphics card slot design, which can support most commercially available graphics card vertical adapter racks for users who want to run their GPU vertically.The design with full openings at the bottom provides a dedicated air duct design for the graphics card, which can help the fan on the power supply compartment absorb air and provide cooling for the graphics card.Equipped with 4 sets of rubber rings, which not only beautifies any cables and covers the cables on the back.There are cable ties attached to the backline and the back of the casing for easy cable management.The installation of a rear-drawn power supply can avoid interference with other cables and make the arrangement and removal of cables more convenient.I/O comes with dust plugs and a Type-C USB connector.Dimensions522 x 230 x 522 mm (DWH)Form FactorFull TowerMaterialsSteel + Plastic + GlassMainboard SupportE-ATX, ATX, Micro-ATX, ITXFront Access & ControlsPower, Reset, USB 3.0 x 2, Type-C 10Gbps x 1, Headphone/Mic Combo Jack, Temp. Display Switch x 1Side Panel4mm Tempered GlassDrive BaysExpansion Slots85.25"/3.5" / 2.5"2/22.5"3FanFront3 x 120mm / 3 x 140mm Top3 x 120mm / 3 x 140mmPower Supply Shroud3 x 120mmRear1 x 120mmIncluded Fan(s)3 x 140mm Tranquil ARGB PWM fans in front + 1 x 120mm Tranquil ARGB PWM fan in rearRadiator SupportFront120/140/240/280/360/420mmTop120/140/240/280/360mmRear120mmClearanceMax GPU Length= 400mmMax CPU Cooler Height= 175mmMax PSU Length(Include cable) = 245mm (with HDD)(Include cable) = 440mm (without HDD)"MiscellaneousDust Filter Front / Top / Bottom / Right SideNet Weight13.04 KgGross Weight15.26 KgWarranty 2 YearsUPC#0-761345-10089-2-Form Factor: Full TowerMotherboard Support: E-ATXPSU: NoneCase Colour: BlackLED Colour: NoneUSB 3.0: 2Side Panel: Tempered Glass